TiSoft ElectricalDesign 24.1: Electrical Installation Design & Calculation Software

TiSoft ElectricalDesign 24.1 is likely a specific service pack or minor update within the v24 release cycle of this electrical engineering software. It is designed for the design, calculation, and verification of low-voltage electrical installations, lighting systems, and short-circuit protection.

Given that specific changelogs for build "24.1" are not universally documented, the core features are typically based on the major version (24) capabilities.

Core Capabilities in v24

• Compliance & Standards: Supports IEC, VDE, and NF C 15-100 standards for international project compliance [citation:1].

• Cable Sizing & Protection: Automated wire sizing based on current-carrying capacity, voltage drop (typically ≤4%), and short-circuit thermal constraints.

• Short-Circuit Calculations: Calculation of Isc (prospective short-circuit current) and peak current (Ip) per IEC 60909.

• Lighting Design: Photometric analysis and lux level calculations integrated into the electrical layout.

• Bill of Materials (BOM): Automatic generation of cable schedules, panel schedules, and material take-offs.

Typical Workflow

1. Single-Line Diagram: Create the network topology with sources, cables, and loads.

2. Load Calculation: Apply diversity factors to determine total demand.

3. Protection Coordination: Select circuit breakers, fuses, and RCDs.

4. Validation: Run automated checks to verify selective coordination and safety.