Installation Steps Please use the following instructions to perform the installation: 1. Log onto your workstation, using an account with Administrator privileges. 2. Place the NX 8.5 DVD into the DVD drive on your system. When the DVD mounts, it will automatically run the launch program and present the launch screen. If this "autorun" feature is turned off for your DVD drive, follow the next two steps to start the launch program. Click on Start Programs Accessories Windows Explorer, and then click on the icon for your DVD drive. Double click on the program launch.exe in the top level folder. 3. Select Install NX from the media Launch screen (if available). {A media launch screen may not be available, or may be disabled on your system} OR Using Windows Explorer, navigate directly to the NX085 folder on the DVD drive, and double click on setup.exe to start the setup program. 4. At the Welcome dialog, click Next to continue. Clicking on the Cancel button at anytime during the installation will discontinue (and roll back) the installation. 5. Installation Type - Select the desired installation type: Typical, Custom or Configure a Mapped Drive. These options are defined as follows: Typical All NX 8.5 products will be installed. Registry entries, shortcuts, and system files will be configured for NX 8.5. Custom By default, only the main UGII kit is selected for this type of installation. You will be able to select additional products that you wish to install. Registry entries, shortcuts and system files will be configured for the selected products.