KISSSOFT.03.2016 KISSsoft Changelog Version 03/2016 - Service Pack 3 KISSsoft - 3D geometry (STEP interface) SP 3 - Checking condition for shaft angle in 3D geometry of face gear In the generation of 3D geometry of face gear, the checking condition if the shaft angle is bigger than 90 degrees was too tight. Thus, sometime it generates an error message and interrupts the process. Now the checking condition is fixed and generates the model without problem. KISSsoft - Bolt calculation SP 3 - Clamped parts table lost units after editing the data base The table for the clamped parts lost its units after the data base tool was opened writable. KISSsoft - CAD interface SP 3 - Solid Edge: Interface to Solid Edge ST9 Interface to Solid Edge ST9 is implemented. KISSsoft - Gear calculation SP 3 - Improvement: Number of harmonics for amplitude spectrum in contact analysis The number of harmonics for amplitude spectrum graphs in contact analysis is increased from 10 to 20. SP 3 - Improvement: Special report of Detailed data for profile, flank line diagram and tooth form The flank normal angle in degrees are added in the special report of Detailed data for profile, flank line diagram and tooth form. Before, only the values in radians were shown. The diameter of the points are also added. SP 3 - Influence of grinding allowance in root diameter If in tab 'Reference profile' the diameters are displayed, and the selected grinding option included the root area, then the grinding allowance was not considered properly for the root diameter of the gear. 1. The display of the root diameter in the user interface was wrong when the selected reference profile was from the database, but the calculation was correct (documentation was also correct). 2. When the selected reference profile was 'own input', both the calculation and the display of the root diameter were wrong. SP 3 - Check of Grinding allowance tolerance Change in the limits: Limitation of the admitted Grinding allowance tolerance is now increased to: Less than 30% of grinding allowance (before 20%) and to less than 200% of tooth thickness tolerance As.e-As.i (2 times bigger as before)