Chemstations ChemCAD VERSION 6.3.2.4389 CHEMCAD New Features and Enhancements * Added a new operating mode, TurboK, which can decrease calculation time for complex simulations (2841) * Replaced License Manager 7.2 with RMS License Manager (see important upgrade message) (3364) * Added the capability to use commuter licensing from non-administrator accounts with RMS (2262) * Added the capability to select equation of state for use with Poynting factor (3151) * Added the capability to regress BIPs from partial pressure data (3306) * Added the capability to set a keyboard shortcut for drawing streams (3414) * Improved KREA with capability for solid-gas reactions (3400) * Added the capability to specify which reaction(s) are deleted for reactor UnitOps (1456) * Improved the default class selection during creation of a new user-defined electrolyte component (2862) * Improved convergence for node flowsheets where some UnitOps are near critical flow (3014) * Enhanced VBClient.xls to enable reporting of unconverged UnitOps (3209) * Revised ideal gas enthalpy for new components using the Joback method (3213) * Added a unit label to the Sherwood-Eckert packing factor in column sizing (3294) * Enhanced stream properties to allow calculation of entropy for a solid (3312) * Enhanced the CHEMCAD Explorer so that stream numbers are still displayed, even after streams are named (3353) * Added a 'Liquid & Solid' section to the Tray Properties report (3389) * Added the capability to set global stream and UnitOp starting ID numbers (3411) * Added the capability to set display preferences for the Run Trace window (3412) CC-THERM * Improved zone temperature calculation for horizontal tube-side condensation with shell-side evaporation (3468) * Added new options to the Nozzle dialog for an X-shell with a three-nozzle connection (3015) * Corrected tube count for no-tube-in-window baffle case (3238) * Corrected an issue where a superheated vapor error message could prevent a user from running a knockback condenser (3265) * Corrected an issue where an error message prevented CC-THERM from running a heat exchanger with liquid-stratified sub-cooling flow (3302) * Added the capability to access fouling factors from Excel Data Maps, controllers, sensitivity studies, etc. (3309) * Corrected an issue with large static head triggering a message about inadequate driving force (3338) * Changed the default value for the outlet mole vapor fraction in the Thermosyphon Reboiler specification dialog (3342) * Added protection for heat curve generation when relevant physical property data is undefined (3348) * Corrected an issue with TEMA sheet reporting the wrong flow for knockback condensers in some circumstances (3403) CC-DYNAMICS * Corrected an issue with BREA 'KREA file not found' message for zero reactions (1235) * Added the capability to run Data Maps for each time step in dynamics mode (1444) * Added warnings for PID controller measured variable outside min/max range (3210)