vERSION 6.2.0 RELEASE NOTES CHEMCAD New Features and Enhancements * Introduced the CHEMCAD Report Writer system, which provides enhanced user-customizable reports (2006) * Added the capability to enter user-created BIPs into a database (1525) * Added the capability to generate equilateral triangular plots (870) * Added the capability to omit unconverged points from a TPXY plot (2223) * Added the capability to optimize OPC performance by selectively limiting the data published via OPC (2224) * Improved System Authorization licensing method to apply to a specific computer rather than to individual users (2210) * Added new examples covering Selexol(TM) carbon capture, reaction rate regression, and multiple-effect evaporation (2196, 2227, 2532) * Added a thermal conductivity mixing rule for electrolytes (682) * Added the capability for OPC users to change feed stream component flow rates, temperature, pressure, velocity, and total flow (800) * Created the Mass and Energy Balances report, which replaces the Convergence report (855) * Added distillation curves D86 and TPB to the available options on the Stream Properties report (912) * Revised and made available packing data for Billet and Schultes method (1330) * Added the window velocity value to the Zone-By-Zone Analysis for shell-side sensible flow and tube-side condensation or evaporation (1516) * Added a multiple-inlet symbol to the Gibbs Reactor sub-palette (1577) * Added the capability to model solid-vapor equilibrium (1710) * Added the capability to edit the PID Controller calculated results on the Misc Settings tab (2032) * Created a warning that displays if the PID controller setpoint value falls outside the sensor's defined range (2033) * Made the Mass Transfer report easier to read (2078) * Changed the name of the Stream Recorder History plot to Stream History (2085) * Added a prompt enabling the user to specify where to store user-defined components for a single component database (2101) * Added UNIFAC subgroups for component 2027, Pentaethylene Hexamine (2164) * Added the capability to include up to 50 different solid components in a single simulation (2193) * Added the capability to specify up to six objects for feed-forward controllers (2240) * Added the capability to reset the UnitOp palette to display the original default icons (2253) * Added a warning message to inform user of incorrect formula entered for user-added component (2282) * Added the capability to set the CHEMCAD 5 import directories from within CHEMCAD 6 (2296) * Changed the Topology report to include the calculation sequence (2308) * Improved mass transfer column convergence (2369) * Improved the TBP/D86 conversion method (2382) * Added the capability to change heat exchanger simulation mode from a DataMap or controller (2467) * Added mass balance view for dynamic simulations (2478) * Added ITAE calculation to the PID controller UnitOp (2482)