Antenna Magus Professional 5.4.0 New antennas added to the database: Waveguide-fed Sinusoidal-profiled (Bowl) corrugated conical horn antenna [MAGUS-15268] Waveguide-fed Gaussian-profiled corrugated conical horn antenna [MAGUS-14711] Conical corrugated horn antenna with various profiles (Linear, Exponential etc.) [MAGUS-15220] Profiled smooth-walled horn antenna [MAGUS-15218] Profiled smooth-walled horn antenna with a dielectric lining [MAGUS-15219] Pyramidal horn antenna with a piecewise linear spline profile [MAGUS-15423] Cornucopia horn-reflector antenna [MAGUS-14416] Circular pin-fed, circularly polarised patch antenna with stubs [MAGUS-14625] 2-by-2 pin-fed microstrip patch array with feed on the underside of the groundplane [MAGUS-15117] Wire helix antenna with linear-taper at feed- and end- points [MAGUS-15134] Wire helix antenna with a conical reflector [MAGUS-15327] Feature extensions and improvements: In the Export mode, all variables may be scaled by a scaling factor before export. Where the frequency required is too high or low for Antenna Magus to complete a proper design for a specific application and antenna, this scaling may be used to scale to the desired frequency. [MAGUS-11840] An option has been added to the Chart Tracer tool to allow excessive data to be decimated during import. [MAGUS-15376] GaN substrates (static and high frequency properties) have been added to the Substrates Library. [MAGUS-14582] The way in which the complex numbers in the input and output of the 2-Port Network tool are displayed has been improved to make them more readable. [MAGUS-15377] When exporting to CST Microwave Studio in some cases cm would have been chosen for the length unit, where mm would have been a better choice. This has been improved. [MAGUS-10199] When switching between Designs and Tweaks within one prototype, the state backup may not always have been correctly triggered. This could have resulted in a loss of information and has been corrected. [MAGUS-15355 ; MAGUS-15401] The message given when a Local Specification has been added to the Shortlist may have been misleading. This has been improved. [MAGUS-15378] Support for library values has been added to the Expansion Package export mechanism. [MAGUS-16298] When exporting Expansion Package models, the local design specification is also included in the XML content. [MAGUS-16411] When deleting a Property Group in a specification, an option has been added to prevent the confirmation dialog being shown again. [MAGUS-15004] In some cases, a floating license may not have been immediately checked in when closing Antenna Magus. [MAGUS-16364] If no updates were found during the check for updates process, the progress bar may have remained idle and shown 0% progress after the update check was completed. This has been corrected. [MAGUS-14462] In some cases a range warning may have been incorrectly shown when moving the sliders of a variable to the minimum or maximum extremes of its range. This has been corrected. [MAGUS-13513] When using a shipped specification to design an antenna, an exception may have occurred in some cases if the specification was not first added to the Shortlist. This has been resolved. [MAGUS-15402] Where the objectives of a design were adjusted and the redesign did not generate parameters, the derived quantities of the original design may not have been cleared. This has been corrected to avoid confusion. [MAGUS-15374] When using Custom Templates, the used/unused keyword checkboxes were not honored. This now works correctly. [MAGUS-15543]