You can set the default format of the standard component name (inserted with Standard component library ). In the Logopress3 settings options > Logopress3 General Options > Standard component name format , you can enter the following keys: ▪ %x : Remove project name. The project name is added by default to the name of the standard component, except if you enter the %x key (not recommended).  In the Logopress3 settings options > Logopress3 Flattening > Attempt to make the blank sketch entities tangent : This option is dedicated to stamped parts . ▪ If deactivated (default): the sketch entities of the blank contour (segment and arcs) are normally created (like in the previous version). ▪ If activated: A smoothness is made attempting to make the contour entities tangent (if possible). The contour can change slightly. NOTE : The former option Transform blank sketch curves into basic lines and arcs is now unused and removed